In your Learner's program you are able to put Targets on Baseline by choosing 'Baseline' as your 'Target Status'. 

A Target with the status of Baseline will always show on the handheld, and will remain visible in each and every session until a YES or a NO is captured for that Target. (Once the data ha been captured, it will show for the entire session but will not re-appear)

• Targets that receive a YES at Baseline, will move through the Target Lifecycle as follows:

                              Baseline   ->   Complete

• Targets that receive a NO at Baseline will move through the Target Lifecycle as follows:

     Baseline  -> Acquisition ->  Generalization ->  Maintenance  -> Complete

Baseline targets will appear as the original data type that you selected, so please make sure that once tested, the criteria results are a yes or a no. The first entry is the only data point that is recorded in a Baseline, regardless of the data type.

• i.e., Probe and Trial by Trial (being yes or no) – if the therapist selects YES then the Target is removed from Baseline and is considered COMPLETE. If the Therapist selects NO then the Target is removed from Baseline, as it failed, and is placed in the queue for Acquisition.

 If you are recording Trial by Trial with Prompt – then a selection of “Independent” = YES, any other answer is a NO

• i.e.,Count (data type + or -) If the Learner fails, leave the count as Zero (‘0’) and hit DONE. If the learner passes, enter +.